vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
HDRC TX2 > < Replace charge pressure control solenoid valve (Y 17 DTL, without air conditioning, LHD)

Corsa C

J745900 Fuel Injection Pump Control Unit, Replace (Y 17 DTL, without AC, LHD)

1. Open bonnet

 Object Number: 2411117 Size: DEFAULT

Caution!

On vehicles from model year 04 with ESP - the steering angle sensor loses its basic adjustment each time the battery is disconnected. It must be recalibrated.

2. Disconnect battery

  • Detach ground cable

3. Raise vehicle

4. Remove injection pump control unit (1)

  • Detach wiring harness plug (2).
  • Remove 4 bolts (arrows)

5. Install fuel injection pump control unit

  • Tighten bolts (9.8 Nm / 7.2 lbf. ft.)
  • Connect wiring harness plug.

6. Lower vehicle

7. Connect battery

8. Calibrate steering angle sensor

  • Switch on ignition

Note:   Rotate the steering wheel one time from its right-hand to its left-hand stop.

9. Program volatile memories

10. Close bonnet

HDRC TX2 > < Replace charge pressure control solenoid valve (Y 17 DTL, without air conditioning, LHD)