|
Transmission Fluid Level, Check and Correct (F
23)
Note: Account must be
taken of the fact that the transmission fluid level may always be
below the checking aperture – up to approx. 20 mm . The transmission fluid level need only
be checked after external leaks and repair/maintenance work on the
transmission and corrected if necessary.
 Remove
| 1. |
Check fluid level
| • |
Unscrew fluid checking bolt (1)
Note: Transmission must
be topped up to lower edge of checking aperture. If necessary,
correct fluid level.
|
|
|
|
| 2. |
Correct fluid level
| • |
Unscrew topping-up bolt (1)
|
| • |
Top up transmission fluid until it escapes at the checking
aperture
Note: Fluid filling
quantity after transmission repair approx. 1.55 litres
|
|
|
|
Install
| 3. |
Install topping-up bolt
| • |
Tighten topping-up bolt (1) 35
Nm
|
|
|
|
| 4. |
Install fluid checking bolt
| • |
Tighten fluid checking bolt (1) 35
Nm
|
|
|
|
|
