Fuel Filter Element, Replace (Diesel Engines)
Important: Fuel
escapes – observe safety measures and national
legislation.
1. |
Remove fuel filter housing
Note: for Y 17 DT, Y 17
DTL for Z 13 DT, Z 13 DTJ
|
2. |
Detach fuel filter housing cover (1) from fuel filter housing
(3)
|
3. |
Remove fuel filter element (2) from fuel filter housing
Note: Store in a
suitable container
• |
Drain remaining fuel from fuel filter housing into a suitable
container.
|
|
|
|
4. |
Open fuel filter housing with EN-46784
Note: For Z 13 DT, Z 13
DTJ
• |
Clamp fuel filter housing in vice with EN-46784-020 (3)
|
• |
Open cover of fuel filter housing (2) with EN-46784-010 (1)
|
|
|
|
5. |
Remove screw-on cover (1) of fuel filter housing (5)
Note: For Z 13 DT, Z 13
DTJ
|
6. |
Remove filter element with upper part of housing (2, 3)
|
8. |
Rotate element (3) anticlockwise through 50°
|
|
|
Install
9. |
Clean inside of fuel filter housing cover and fuel filter
housing
Note: With lint-free
cloth
|
10. |
Insert fuel filter element
• |
Fill fuel filter housing with clean diesel fuel up to just
below the edge
|
|
11. |
Assemble components of fuel filter element
Note: Assemble as shown
in illustration, use new gaskets.
1. |
Central bolt - tightening torque 6 Nm |
2. |
Gasket, central bolt |
3. |
Heated fuel filter housing lid. |
4. |
Fuel filter housing lid seal |
5. |
Fuel filter element |
6. |
Fuel filter housing |
|
|
|
12. |
Assemble components as illustrated
Note: For Z 13 DT, Z 13
DTJ
|
13. |
Insert new filter element (3)
|
14. |
Replace seal ring (4)
|
15. |
Turn element (3) 50° clockwise in upper part of housing
(2)
Note: The upper part of
the housing only fits in one installation position. Incorrect
assembly is not possible.
|
16. |
Position screw-on cover (1) on fuel filter housing (5)
|
17. |
EN-46784-20 clamped in vice
|
18. |
Screw in screw-on cover (1) and tighten with EN-46784-10
Note: Tightening torque
30 Nm
|
|
|
19. |
Install fuel filter housing
Note: For diesel
engines or for diesel engines, Z 13 DT, Z 13 DTJ
|
|