|
Replace both rear springs and damper rings
 Remove
| 1. |
Detach gaiter (arrow) on handbrake lever
| • |
Unclip gaiter
| – |
Push gaiter over handbrake lever
|
|
|
| 2. |
Release handbrake
| • |
Remove protective cap (2)
|
| • |
Loosen nut (1) from handbrake cable
|
|
|
|
| 3. |
Remove rear wheels.
| • |
Unscrew 10x or 8x wheel bolts
Note: Mark position
relative to wheel hub
|
|
|
| 4. |
Place hydraulic jack KM-904 A and
CH-48374 (3) below rear axle and
align
Note: Check for correct
position and attachments! See magnifying glass in diagram.
| • |
Raise hydraulic jack until rear axle lies against CH-48374 (3) (magnifying glass)
|
|
| 5. |
Detach 2x dampers lower
| • |
Unscrew 2x bolt (2), (4)
|
|
| 6. |
Remove 2x coil springs (1)
| • |
Lower hydraulic jack until coil springs can be removed
|
| • |
Remove 2x coil springs (1) with damper rings
|
|
|
Install
| 7. |
Insert 2x rear springs
| • |
Lower hydraulic jack until rear axle is free
|
| • |
Insert 2x coil springs with damper rings top and bottom
Note: Note installation
positions
|
|
| 8. |
Attach dampers at bottom both sides
|
| 9. |
Attach rear wheels
| • |
Tighten 10x or 8x wheel bolts 110
Nm
|
|
|
