|
Replace catalytic converter monitor oxygen
sensor
 Remove
| 3. |
Raise vehicle by its full height
|
| 4. |
Remove catalytic converter check oxygen sensor (3).
| • |
Disconnect wiring harness plug (2)
|
| • |
Carefully unscrew oxygen sensor, catalytic converter control
using EN-6129 (1)
|
|
|
|
Install
| 5. |
Install oxygen sensor for catalytic converter control
| • |
Apply assembly paste (black) to thread
Note: Only when reusing
oxygen sensor, new oxygen sensors are already pretreated.
|
| • |
Tighten oxygen sensor, catalytic converter control using EN-6129
| – |
Tightening torque 40 Nm .
|
|
| • |
Connect wiring harness plug
|
|
| 6. |
Lower vehicle by its full height
|
|
