Replace axle shaft seal rings (F13+/F13+
MTA/F17+)
Remove
1. |
Remove affected axle shaft from transmission .
|
2. |
Remove affected axle shaft seal ring
• |
Pull axle shaft seal ring out of transmission housing with
KM-J-7004 (1) and KM-586 (2)
|
|
|
|
Install
3. |
Install new axle shaft seal ring
• |
Coat new axle shaft seal ring with transmission fluid
|
• |
Drive in flush with KM-446 (1)
|
|
|
|
4. |
Install axle shaft in the transmission
|
5. |
Check transmission fluid level and correct if necessary
|
|