Vauxhall Workshop Service and Repair Manuals

Axle Shaft Seal Rings and O Ring in Left Sealing Flange, Replace (M20/M20 MTA/M32)

  Remove

1.	Remove affected axle shaft from transmission Note:   Place collecting pan underneath - transmission fluid will escape Axle shaft remains in wheel hub. •   Vehicles without intermediate shaft •   Vehicles with intermediate shaft

3.   Only right side: •   Remove axle shaft seal ring – remove with KM-J-7004 (2) and KM-586 (1)

4.   Only left side: •   Remove sealing flange (1) – Unscrew 4x bolts (2) – Remove sealing flange 5.   Remove axle shaft seal ring •   Place sealing flange on KM-466-2 (5) •   Press axle shaft seal ring out with KM-523-1 (3) and KM-523-3 (4)

6.   Remove O-ring (2) •   Use a small screwdriver to take the O-ring out of the sealing flange (1)

  Install

7.   Fit O-ring (2) •   Coat O-ring with transmission fluid and apply to the sealing flange (1)

8.   Install axle shaft seal ring, right side: •   Coat axle shaft seal ring with transmission fluid – Drive axle shaft seal ring flush into transmission with KM-519 (1)

9.   Install axle shaft seal ring, left side: •   Coat axle shaft seal ring with transmission fluid •   Press axle shaft seal ring into sealing flange with KM-519 (1) 10.   Install sealing flange (2) •   Insert sealing flange •   Tighten 4x bolt (3) 20 Nm + 45°

12.	Install axle shaft affected in the transmission •   Vehicles without intermediate shaft •   Vehicles with intermediate shaft