Replace gasket of differential gear cover
(F13+/F13+ MTA/F17+)
Remove
1. |
Remove crossmember (2)
|
2. |
Detach rear torque support bracket (4) from transmission
|
3. |
Remove rear torque support (3)
• |
Undo rear torque support bolt from front axle body
Note: Differential gear
cover bolts (1) are now accessible.
|
|
|
|
4. |
Place collecting basin underneath.
|
5. |
Remove differential gear cover
• |
Unscrew 10x bolt
Note: Release
differential gear cover by tapping gently with a rubber mallet if
necessary. Transmission fluid runs out.
|
|
6. |
Remove gasket for differential gear cover
|
|
|
Install
7. |
Clean sealing surfaces.
|
8. |
Fit differential gear cover to transmission with new gasket
• |
Stick gasket to differential gear cover with grease
|
• |
Screw down the cover
– |
Sheet metal version 30 Nm
|
|
|
9. |
Attach rear torque support bracket to transmission with new
bolts
• |
Tighten 2 bolts 80 Nm + 45° –
60°
|
|
10. |
Attach rear torque support
|
12. |
Check transmission fluid level and correct if necessary
|
|