Pressure Line, Transmission Housing to Central
Release, Replace (F13+/F 17+)
Remove
2. |
Detach connecting piece from pressure line
• |
Release clamp (1) from connecting piece and remove
|
• |
Bend clip together a little and insert back into connecting
piece
|
|
3. |
Remove central release
|
4. |
Remove pressure line from below
• |
Unclip pressure line from pressure line sleeve with suitable
screwdriver (arrow)
|
|
|
|
Install
5. |
Check seal ring (1) of pressure line, pressure line and
pressure line sleeve for damage
Note: Replace seal ring
if necessary.
|
6. |
If pressure line sleeve is being replaced (arrow) - release
pressure line sleeve from clutch housing and remove from above.
• |
Insert pressure line sleeve into clutch housing
Note: Ensure that the
lug (arrow) sits in the sleeve in the clutch housing groove.
|
|
7. |
Pay attention to seating and condition of seal rings
Note: Damaged seal
rings lead to leaks.
|
8. |
Insert pressure line into pressure line sleeve from below
Note: Pressure line
must engage in sleeve.
|
|
|
9. |
Install central release
|
10. |
Attach connecting piece to pressure line
Note: Clamp must
audibly engage.
|
|