Transmission Shift Linkage, Adjust (F13+/F17+)
Remove
1. |
Undo shift guide clamp
• |
Only slacken bolt (1) do not unscrew
|
|
|
|
2. |
Unclip manual shift lever gaiter from centre console
|
3. |
Lock manual shift lever in adjustment position
• |
Unclip the reverse gear inhibit connection (1) from the
gearshift knob.
|
• |
Push the reverse gear locking piece on the gear shift lever
upward and rotate 90°
|
• |
Pivot the gear shift lever to the left and insert the reverse
gear locking piece with locking pin (2) into the stop (3) on the
left
|
|
|
|
4. |
Lock gearshift lever shaft in the gearbox cover
• |
Turn gearshift rod anti-clockwise
|
• |
Engage locking pin (1) in the adjusting bore in the gearbox
cover (arrow)
|
|
|
|
Install
5. |
Attach shift guide clamp
• |
Tighten bolt 12 Nm + 225°
|
|
6. |
Unlock the gearshift lever
• |
Push the reverse gear locking piece on the gearshift lever
upward and rotate back 90°
|
• |
Push the reverse gear locking piece downward
|
• |
Clip the reverse gear inhibit connection to the gearshift
knob
|
|
7. |
Remove locking pin
Note: Locking pin in
adjusting bore hole releases automatically when first shifted in
"R" direction – if necessary release locking pin by hand.
|
8. |
Clip manual shift lever gaiter to centre console
|
9. |
Check ease of gear shifting
|
|