|
Transmission Shift Linkage, Adjust (M20/M32)
 Remove
| 1. |
Push the adjuster (1) onto the selector cable and lock
|
|
|
|
| 2. |
Lock shift actuation at the transmission
| • |
Pull shift actuation upwards (arrow)
|
| • |
Attach KM-527-A (1) to shift
actuation
|
|
|
|
| 3. |
Detach cover of manual shift lever (1)
| • |
Unclip manual shift lever cover from centre console
|
| • |
Prop up cover of manual shift lever with cover frame
|
|
| 4. |
Remove gearshift knob
| • |
Unclip the reverse gear inhibit connection (2) from the
gearshift knob.
|
| • |
Pull off gearshift knob
|
|
|
|
| 5. |
Lock manual shift lever in adjustment position
| • |
Slide reverse gear catch on gearshift lever up and twist
counterclockwise by 90°.
|
| • |
Pivot the gearshift lever to the left, and insert the reverse
gear locking piece with catch (1) into the mount (2) on the
left
|
|
|
Install
| 6. |
Loosen the adjuster on the selector cable
| • |
Press the catch (1) toward the back
|
|
|
|
| 7. |
Unlock manual shift lever
| • |
Slide reverse gear catch on gearshift lever up and twist back
clockwise by 90°.
|
| • |
Push the reverse gear locking piece downward
|
|
| 8. |
Install gearshift knob
| • |
Push gearshift knob onto gearshift lever as far as it will
go
|
| • |
Clip the reverse gear inhibit connection to the gearshift
knob
|
|
|
| 9. |
Detach KM-527-A (1)
Note: Pull shift
actuation slightly upwards (arrow).
|
|
| 10. |
Check ease of gear shifting
|
| 11. |
Attach cover of manual shift lever
| • |
Clip manual shift lever cover to centre console
|
|
|
