Remove and install shift actuator assembly
(F13+/F17+)
Remove
1. |
Remove the gaiter cover (1) from the centre console
|
2. |
Unclip the reverse gear inhibit connection (2) from the
gearshift knob.
|
3. |
Remove gearshift knob
• |
Push retaining disc (3) upwards
|
• |
Pull off knob with gearshift lever cup
|
|
|
|
4. |
Detach gearshift rod from relay point
|
|
|
5. |
Remove front exhaust pipe
• |
Separate oxygen sensor wiring harness plug
|
• |
Release clamp
– |
Separate plug connection
|
|
|
6. |
Loosen gearbox extension housing
|
7. |
Detach heat shield
• |
Remove gearbox extension housing with heat shield
|
|
|
|
Install
8. |
Insert gearbox extension housing installation aid
• |
Insert guide sleeve with tab (1) into the gearbox extension
housing at the front left
Note: The tab is
intended for a lining of the front installations sleeve and is
broken off after being pressed in. The sleeves remain in the
vehicle.
|
• |
Insert guide sleeve without tab (2) into the gearbox extension
housing at the rear left
|
|
|
|
9. |
Install gearshift actuator assembly with heat shield
• |
Tighten 4 bolts (1) 22 Nm
Note: Pay attention to
the tightening sequence. First, the rear left bold (guide sleeve
without elongation hole), then the front left (guide sleeve with
elongated hole), then the right side.
|
|
10. |
Fasten the heat shield
|
|
|
11. |
Install front exhaust pipe
• |
Fasten clamp
– |
Connect plug connection
|
|
• |
Connect oxygen sensor wiring harness plug
|
|
12. |
Push the reverse gear locking piece on the gear shift lever
upward and rotate 90°
|
13. |
Insert reverse gear locking piece with locking pin into hole on
left
|
14. |
Lock gearshift lever shaft in the gearbox cover
• |
Turn gearshift rod anti-clockwise
– |
Direction of 1st/2nd gear
|
|
• |
Engage locking pin in the adjusting bore in the gearbox
cover
|
|
15. |
Tighten shift guide clamp
|
16. |
Push the reverse gear locking piece on the gearshift lever
upward and rotate back 90°
|
17. |
Push the reverse gear locking piece downward
|
18. |
Attach gearshift knob
• |
Push on knob with gearshift lever cup
|
• |
Push locking disc downward
|
|
19. |
Clip the reverse gear inhibit connection to the gearshift
knob
|
20. |
Clip gaiter cover to centre console
|
|