|
Install
Insert new brake pressure hose at bracket in wheel housing and
spring strut dome and insert retaining plates. Connect wiring
harness plug for wheel sensor at wheel housing and clip in
bracket.
Insert wiring harness for wear indicator sensor in brackets with
clips.
Fit brake lines on brake pressure hose – tightening torque
16 Nm / 12 lbf. ft. Fit banjo bolt, brake pressure hose on brake
caliper – tightening torque 40 Nm / 29.5 lbf. ft. (use new
seal rings). Fit front wheel – tightening torque 110 Nm / 81
lbf. ft.
Inspect
Bleed brake system and check for leaks – see operation
"Brake System, Bleed" and "Brake System, Check for Leaks".
|
