|
Engine, Repair Using Short-block
|
 Remove
Remove engine – see operation "Engine, Remove and
Install".
Detach transmission from engine – see operation "Manual
Transmission from Engine, Detach and Reattach".
Remove
Remove oil pump – see operation "Oil Pump, Remove and
Install".
Remove bearing bridge attachment screws (1 and 2). Remove
bearing bridge.
In vehicles with automatic transmission: Remove drive plate
– see operation "Drive Plate, Remove and Install".
|
|
|
Remove crankshaft pulse generator (1) holder and crankshaft
pulse generator (2) (1 attachment screw).
Remove oil filter housing – see operation "Oil Filter
Housing, Remove and Install".
Remove fuel injection pump – see operation "Fuel Injection
Pump, Remove and Install". Remove fuel injection pump bracket.
Install
Install fuel injection pump bracket. Install fuel injection pump
– see operation "Fuel Injection Pump, Remove and
Install".
Install oil filter housing – see operation "Oil Filter
Housing, Remove and Install".
|
|
In vehicles with automatic transmission: Install drive plate
– see operation "Drive Plate, Remove and Install".
Install pulse pick-up bracket with pulse pick-up –
tightening torque 9 Nm / 6.5 lbf. ft.
Attach bearing bridge to cylinder block – tightening
torque 23 Nm / 17 lbf. ft.
Install oil pump – see operation "Oil Pump, Remove and
Install".
Attach transmission to engine – see operation "Manual
Transmission from Engine, Detach and Reattach".
Install engine – see operation "Engine, Remove and
Install".
|
