Subject:
Engine
Oil Heat Exchanger Cover and Engine Ventilation Housing
Vehicles:
All
Vectra-A/Cavalier, Calibra and Omega-B with V6 DOHC petrol engine (C 25 XE, X
25 XE and X 30 XE)
Condition:
With
the above-mentioned engines, the sealing of the heat exchanger cover and of the
engine ventilation housing to the cylinder block is being changed in
production. The current moulded gaskets are being replaced by a liquid gasket
(silicone sealing compound).
The oil deflector located in
the moulded gasket on the old engine ventilation housing is integrated in the
new engine ventilation housing.
Remedy:
1.
Engine oil heat exchanger cover:
With
both the old version with moulded gasket (seal ring) and the new version with
liquid gasket, sealing with liquid gasket is undertaken after removing the
cover.
Clean
the sealing surfaces of the cover and cylinder block; they must not display
any score marks or scratches. Then apply the liquid gasket to the entire
circumference of the cover and immediately install "wet" (illus.
F 3234, dimension I approx. 2 mm/0.08 in.).
Note:
The
groove of the new cover has been changed in the area of the through holes for
the fastening screws. Independently of this change, the old cover may also be
re-used in case of repair.
|
|
2.
Engine ventilation housing
Do
not re-use the old housing and gasket with oil deflector after
removal, but replace it with a new housing with integrated oil deflector and
liquid gasket.
After
removing a new housing with integrated oil deflector and liquid gasket, clean
the sealing surfaces of the housing and cylinder block; they must not display
any score marks or scratches.
To
install the new housing with integrated oil deflector, apply liquid gasket to
the sealing surface of the housing and immediately install "wet"
(illus. F 3236, dimension I approx. 2 mm/0.08 in.).
|
|
Parts:
Designation
|
Number
|
Part No.
|
Catalogue No.
|
Engine
oil heat exchanger cover
|
1
|
90 501 955
|
6 50 831
|
Engine
ventilation housing with integrated oil deflector
|
1
|
90 502 186
|
6 56 484
|
Liquid
gasket (silicone sealing compound)
|
-
|
90 511 124
|
15 03 296
|
Time
Allowance:
J
3156 00 Oil Cooler - Replace 2.3
hrs. Vectra-A/Cavalier, Calibra
TC:
01, 04, 12, 27, 42 3.1
hrs. Omega-B
Add:
01 For
vehicles with lower engine compartment cover .2 hrs.
J
9513 00 Flange of Cylinder Block Ventilation - Remove 1.0
hrs. Vectra-A/Cavalier, Calibra
and
Install
TC:
01, 42 2.6
hrs. Omega-B
W
1000 00 Vehicle from Parking Place to Workshop and Back .2
hrs.
TC: 99
Note:
In
the Labour Times microfiche, the engine ventilation housing is designated as
the flange of the cylinder block ventilation and the engine oil heat exchanger
as the oil cooler.