· Engine is not in the start phase
· Engine speed higher than 520 rpm
· Mass air flow meter signal lower than
3.0 kg / h (short circuit to ground)
Note:
· The fault can generally be expected to
be caused by defects in the wiring.
Replacement
value:
· The control unit takes a replacement
value for the load signal which depends on the engine speed and the throttle
valve angle.
· If the throttle valve potentiometer is
also defective, the following replacement values are used for calculation:
For
engine speed lower than 1520 rpm with load signal = 2.5 ms
For
engine speed higher than 1520 rpm with load signal = 4.8 ms
|