Vauxhall Workshop Service and Repair Manuals

Detach wiring harness plug from DIS ignition module – accessible from underside of vehicle.

Fastening bolt (1) with engine transport shackle from camshaft housing.

Remove fastening bolts (2) and (3) from cylinder head.

Cable bundle from DIS ignition module bracket – unclip.

Remove DIS ignition module upwards.

Detach ignition cable plugs from DIS ignition module.

Mark installation position and detach DIS ignition module from bracket.

Install DIS ignition module on bracket – tightening torque 8 Nm / 6 lbf. ft.

Fasten ignition cable plugs to DIS ignition module.

Caution

Note ignition sequence – cylinder numbers are on ignition cables and on DIS ignition module.

Attach DIS ignition module bracket to camshaft housing and cylinder head – tightening torque 15 Nm / 11 lbf. ft.

Connect wiring harness plug (1) to DIS ignition module.

Clip cable bundle onto DIS ignition module bracket.