Vauxhall Workshop Service and Repair Manuals

When replacing transmission transfer following attaching parts:

Torque

Install fluid cooler line for transmission inlet (1) with new seals rings and tighten – 25 Nm / 18 lbf. ft. Install fluid cooler line for transmission outlet (2) to neck and tighten – 30 Nm / 22 lbf. ft.

Transfer rear engine suspension (arrows); remove and reinstall transmission crossmember to rear engine suspension.

Torque

Rear engine suspension – 40 Nm / 29.5 lbf. ft. Transmission crossmember to rear engine suspension – 20 Nm / 15 lbf. ft.

Selector connecting lever (3) with selector linkage – 20 Nm / 15 lbf. ft. Selector lever position switch (2) – 13 Nm / 9.5 lbf. ft., beforehand, adjust selector lever position switch – see operation "Selector Lever Position Switch, Adjust".

Cover plate (4) for selector lever position switch. If present, bracket (1) – 20 Nm / 15 lbf. ft. Transmission output speed sensor – 12 Nm / 9 lbf. ft.

Insert converter – with KM-574 (in connection with diesel engine with KM-899). Illustration shows transmission with converter for 4 cylinder petrol and V6 engines.

  Inspect

If centring bolts remain in transmission flange, remove carefully using flat pliers and insert into corresponding bore holes in engine block.