Vauxhall Omega B Workshop Service and Repair Manuals

Important:   Always bleed hydraulic clutch actuator from "bottom" to "top", otherwise clutch problems and malfunctions will occur.
Always use DOT 4 brake fluid.
Manual bleeding is not permitted.

Remove cover from brake fluid reservoir.

Fit brake bleeder (1) adapter to brake fluid reservoir.

Fit MKM-6174-A (2) to brake bleeder adapter.

Place end of hose into suitable collecting basin.

Raise vehicle. If present: Remove transmission cover.

Remove valve cap from bleeder valve. Slide MKM-6174-A (3) onto bleeder valve until it can be heard to engage.

Switch on brake bleeder and open bleeder valve (1).

Bleed until clear, bubble-free brake fluid comes out of MKM-6174-A (2) at brake bleeder adapter.

Close bleeder valve - tightening torque 9 Nm .

Switch off brake bleeder.

Remove MKM-6174-A from bleeder valve by pressing lever. Fit valve cap to bleeder valve.

If present:fit transmission cover (4 attachment screws) - tightening torque 15 Nm .

Lower vehicle.

Remove hose (3) from brake bleeder adapter (2).

Detach brake bleeder adapter from brake fluid reservoir (1).

  Inspect

Check brake fluid level and correct to "MAX" on brake fluid reservoir.

Replace brake fluid reservoir cover.