Actuator, Remove and Install or Replace or Replace
Actuator, Remove and Install or Replace
Notice:
The control unit for the electronic cruise control is integrated into the actuator.
Remove, Disconnect
Disconnect guide tube from actuator by turning 1/4 to the left. Detach Bowden cable nipple from actuator. Loosen 3 nuts from studs on engine compartment side panel.
Remove actuator. Release and disconnect wiring harness plug.
Install, Connect
Connect wiring harness plug. Place actuator on studs and fasten with 3 nuts. Attach Bowden cable nipple (1) to actuator.
Attach guide tube to actuator with a 1/4 turn to the right.