C-07, Pretensioning Device Right Circuit
|
C-07, Pretensioning Device Right Circuit |
|
Test |
Work Order Description |
Nominal Value |
|
T01 |
Check: Short Circuit in Wiring Harness |
|
|
|
• Ignition OFF • Disconnect wiring harness connector from:
U27 Squib - Belt, RH • Ignition ON • Diagnostic Tester Data List Parameter
RIGHT PRET. RES.
|
greater than 6 Ohm |
|
|
Yes: T02 |
No: E05 |
|
T02 |
Check: Interruption in Wiring Harness |
|
|
|
• Connect fused jumper wire to:
U27 Squib - Belt, RH
Wiring Harness Connector (wiring harness side) Terminal 6
&
U27 Squib - Belt, RH
Wiring Harness Connector (wiring harness side) Terminal 8 • Diagnostic Tester Data List Parameter
RIGHT PRET. RES.
|
less than 1 Ohm |
|
|
Yes: T03 |
No: E04 |
|
T03 |
Check: Short to Voltage/Ground of Signal Circuit |
|
|
|
• Measure voltage between the following terminals:
U27 Squib - Belt, RH
Wiring Harness Connector (wiring harness side) Terminal 6, 8
&
Ground Note: Do not remove fused jumper wire
|
0.5 ... 2.5 V |
|
|
Yes: E01 |
No: T04 |
|
T04 |
Check: Short to Voltage/Ground of Signal Circuit |
|
|
|
• Measure voltage between the following terminals:
U27 Squib - Belt, RH
Wiring Harness Connector (wiring harness side) Terminal 6, 8
&
Ground Note: Do not remove fused jumper wire
|
less than 0.5 V |
|
|
Yes: E02 |
No: E03 |
|
C-07, Pretensioning Device Right Circuit |
|
Result |
Cause Of Fault |
|
E01 |
• Defective component:
U27 Squib - Belt, RH
|
|
E02 |
• Short circuit to ground between:
X90 Instrument Panel & Control Unit - Airbag 30P
Wiring Harness Connector Terminal 10
&
U27 Squib - Belt, RH
Wiring Harness Connector (wiring harness side) Terminal 6 or • Short circuit to ground between:
X90 Instrument Panel & Control Unit - Airbag 30P
Wiring Harness Connector Terminal 11
&
U27 Squib - Belt, RH
Wiring Harness Connector (wiring harness side) Terminal 8 or • Defective component:
K31 Control Unit - Airbag
|
|
E03 |
• Short circuit to voltage between:
X90 Instrument Panel & Control Unit - Airbag 30P
Wiring Harness Connector Terminal 10
&
U27 Squib - Belt, RH
Wiring Harness Connector (wiring harness side) Terminal 6 or • Short circuit to voltage between:
X90 Instrument Panel & Control Unit - Airbag 30P
Wiring Harness Connector Terminal 11
&
U27 Squib - Belt, RH
Wiring Harness Connector (wiring harness side) Terminal 8 or • Defective component:
K31 Control Unit - Airbag
|
|
E04 |
• Circuit interruption between:
X90 Instrument Panel & Control Unit - Airbag 30P
Wiring Harness Connector Terminal 10
&
U27 Squib - Belt, RH
Wiring Harness Connector (wiring harness side) Terminal 6 or • Circuit interruption between:
X90 Instrument Panel & Control Unit - Airbag 30P
Wiring Harness Connector Terminal 11
&
U27 Squib - Belt, RH
Wiring Harness Connector (wiring harness side) Terminal 8 or • Defective component:
K31 Control Unit - Airbag
|
|
E05 |
• Short circuit in wiring harness between:
X90 Instrument Panel & Control Unit - Airbag 30P
Wiring Harness Connector Terminal 10
&
X90 Instrument Panel & Control Unit - Airbag 30P
Wiring Harness Connector Terminal 11 or • Defective component:
K31 Control Unit - Airbag
|
|
