Beetle L4-1.9L DSL Turbo (ALH) (1998)
/Page-1674003.png)
^
Tool #4, for installing cable on one-notch pulleys with offset reinforcing ribs (arrows).
Window regulator, repairing
Identifying repair procedure
Remove window regulator motor from carrier assembly, loosen carrier from door. See Repair Manual Group 64 in Elsaweb.
Tip: It is not necessary to completely remove carrier from vehicle to perform repair.
To allow carrier to be placed inside vehicle as shown:
^
Disconnect mirror and speaker connectors.
^
Reach behind carrier and pinch first and second wiring harness cables ties (arrows) and push through carrier (this allows enough slack in harness
to pivot carrier to position shown).
^
Place carrier assembly inside vehicle on a clean protective surface such as VAS 5193 fender cover (as shown) to protect seat, interior trim and
door sill trim.
^
Check integrity of cables, clamps and pulleys.
If cables or clamps are damaged:
^
Install Kit (cable assembly and clamps).
^
In addition, on opposite side, replace clamps (unless opposite side has been previously repaired using parts listed in previous table) using clamps
from a second kit (discard unused cable from second kit).
Prior to start of repairs:
