Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Lower subframe using VAG1383A engine/transmission jack.
Installing
Before installing bolts for subframe, position steering gear on subframe and install bolts for steering gear.
-
Threaded sleeve -1- of steering gear must seat in subframe hole
Installation is the reverse of removal.
-
After installing check position of steering wheel during test drive.
-
If the steering wheel is not in the straight ahead position:
-
Check front wheel alignment.
Fastener/location - Tightening torque
Ball joint to control arm: .......................................................................................................................................... 20 Nm (15 ft. lbs.) + 1/4-turn (90°)
Use new bolts!
Steering gear to subframe: ........................................................................................................................................ 20 Nm (15 ft. lbs.) + 1/4-turn (90°)
Use new bolts!
Connecting link to stabilizer bar: ......................................................................................................................................................... 30 Nm (22 ft. lbs.)
Subframe to chassis: ............................................................................................................................................... 100 Nm (74 ft. lbs.) + 1/4-turn (90°)
Use new bolts!
Transmission support
-
Bolts -A-: ......................................................................................................................................................... 20 Nm (115 ft. lbs.) + 1/4-turn (90°)
-
Bolts -B-: ........................................................................................................................................................... 40 Nm (30 ft. lbs.) + 1/4-turn (90°)
-
Always replace bolts.