Beetle L4-1.9L DSL Turbo (ALH) (1998)
Trunk / Liftgate Lock: Service and Repair
Rear Lid Lock, Removing and Installing
1 - Lock cylinder carrier
- The lock cylinder can only be removed with the carrier.
- Removing and installing. See: Lock Cylinder Carrier, Removing and Installing (Power)
2 - VW emblem
- Assemble with carrier -1-
- Removing:
- Remove lock cylinder carrier. See: Lock Cylinder Carrier, Removing and Installing (Power)
3 - Water drain channel (rubber)
- Fasten to carrier with tie wrap
CAUTION: Ensure the rubber drain channel is routed correctly, otherwise water will drain onto the lock and into the trunk.
4 - Trunk lid
5 - Lock
- Removing:
- Remove rear lid trim refer to "Rear Lid Upper Trim, Removing and Installing and Rear Lid Lower Trim, Removing and Installing" See: Doors,
Hood and Trunk/Trunk / Liftgate/Service and Repair
- Disconnect connector on lock.
- Unclip operating rod -9-, and remove lock from trunk lid.
6 - Bolt
- 23 Nm (17 ft lb)
7 - Lock plate
- Adjusting - within slotted holes
- Removing:
- Remove lock carrier trim refer to "Lock Carrier Trim, Removing and Installing". See: Doors, Hood and Trunk/Trunk / Liftgate/Service and
Repair
- Remove screws -B-.