Beetle L4-1.9L DSL Turbo (ALH) (1998)
The mark -arrow- on the rear of the guide upper section -1- must, on both sides, lie within the marks -dimension a- on the guide rail gate -2-.
The slotted guide rail -2- must be located in the guide rails (cannot be moved by hand).
If this is not the case, adjust parallel running.
-
Place sunroof on from above and screw in securing screws (guide rail/panel).
-
Lightly tighten securing screws (Torx T 25).
NOTE: After adjusting panel height tighten securing screws (4.5 Nm).