Beetle L4-1.9L DSL Turbo (ALH) (1998)
^
Always replace
3. Oil cooler
4. Gasket
^
Always replace
^
Install into oil cooler groove
5. Seal
^
If seal leaks nip open and replace.
6. Plug
^
10 Nm (7 ft. lbs.)
7. Sealing plug
^
Do NOT open
8. Spring
^
For pressure relief valve approximately 5 bar
9. Piston
^
For pressure relief valve approximately 5 bar
10. 0.9 bar oil pressure switch -F1-
^
25 Nm (18 ft. lbs.)
11. Gasket
^
Always replace
12. 15 Nm (11 ft. lbs.) plus additional1/4 turn (90°)
^
Always replace
^
Place bolts first top left and right then tighten all four bolts over cross
13. Oil filter bracket
14. Seal
^
Always replace
15. Oil supply pipe
^
To the turbocharger
16. Banjo bolt
^
20 Nm (15 ft. lbs.)
17. Sealing cap
^
25 Nm (18 ft. lbs.)
^
Loosen and tighten using 3417 oil filter wrench
18. O-ring
^
Always replace
19. Oil filter element
Fig. 1 Dipstick, markings
1. MAX. mark
2. MIN. mark
a. Area above cross-hatched zone up to the MAX. mark:
Do not top-up with engine oil!
b. Oil level within cross-hatched zone:
Can be topped-up with engine oils as necessary
c. Area from MIN. mark up to cross-hatched zone:
Fill with 0.5 ltr. (0.47 quarts) of engine oil maximum!