Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Apply silicone sealing bead as shown to the clean sealing surface of the oil pan. (illustration shows position of sealant bead on cylinder block).
-
Immediately install oil pan and lightly tighten all bolts.
Note: The oil pan must be aligned Rush with the cylinder block.
-
Tighten oil pan bolts to 15 Nm (11 ft. lbs.).
-
Tighten oil pan/transmission bolts to 45 Nm (33 ft. lbs.).
Note:
^
After installing the oil pan, allow the sealant to dry for approximately 30 minutes before adding engine oil.
^
Assembly is the reverse of the disassembly sequence.