Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Install adjustment device 2068 A as shown.
-
Set adjustment device to 96 mm -arrow A-. The left-hand notch of the vernier scale is the reference point.
-
Turn crankshaft until flywheel TDC marking aligns with point on setting device -arrow B-.
Vehicles with Automatic Transmission
-
Install adjustment device 2068 A as shown.
-
Set adjustment device to 96 mm -arrow A-. The left-hand notch of the vernier scale is reference point.
-
Turn crankshaft until flywheel TDC marking aligns with point of setting device -arrow B-.
All Vehicles
-
Lock camshaft using setting bar.
-
Centralize setting bar as follows: Turn camshaft so that one end of setting bar contacts the cylinder head. Using feeler gauge establish the gap
at the other end of the setting bar. Place a feeler gauge corresponding to halt the gap between setting bar and cylinder head. Turn camshaft
until the setting bar contacts the feeler gauge. Place a 2nd feeler gauge, of same thickness, at the other end between setting bar and cylinder
head
-
Lock injection pump sprocket with pin.
-
Loosen injection pump sprocket mounting bolts -1-.
Note:
Do Not loosen hub nut -2-! Otherwise the Diesel injection pump basic setting will be altered and cannot be reset with normal workshop equipment.
-
Loosen Tensioner.