1998 Beetle L4-19L DSL Turbo HVAC Housing: Service and Repair
- Removing Fig. 1 in "Heating and Ventilation System, Servicing". See: Service and Repair
10 - Self-tapping screw
11 - Central flap lever
- Installing and adjusting see Fig. 1 below.
12 - Temperature flap lever
13 - Base plate
14 - Heater core bulkhead seal
- Note installation position
- Installing see Fig. 2 below.
Fig. 1 Central flap lever, installing and adjusting
The central flap pinion has an adjustment mark.
-
Install the lever so that the notches on the lever and the pinion align -arrows-.
Fig. 2 Heater core bulkhead seal, installation position
The seal between the heater core and the bulkhead has a positioning mark.
-
Install the seal -1- so that the notches on the seal and the base plate -2- align -3-.
Servo motor for fresh/recirculating air door -V154-, removing and installing
Removing
-
Remove glove box.
See Glove box, removing. See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair