Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Disconnect electrical connector -1-.
-
Remove screw -3-.
-
Swing motor -2- downwards.
-
Disconnect motor -2- from fresh air/recirculating air door lever.
Installing
Replacement motors are supplied with operating levers in the "recirculating air" position. To ease installation, first do the following:
-
Attach electrical connector -1- to flap motor -2-.
-
Switch on ignition.
-
Operate button for fresh air/recirculating air and observe lever position.
-
When the center position is reached, quickly disconnect the electrical connector.
-
Insert motor onto the fresh air/recirculating air shaft -1-.
NOTE: If it's difficult to align and fit the motor to shaft -1-, remove fresh air blower -V2-, see Fig. 1 in "Heating and Ventilation System, Servicing"
and position flap/shaft as required. See: Service and Repair
-
Turn motor in direction of arrow -A-.
-
Install mounting screw.
-
Reconnect electrical connector.