Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Turn crankshaft until flywheel TDC marking aligns with point on setting device (arrow -B-).
Vehicles with automatic transmission
-
Install adjustment device 2068 A as shown.
-
Set adjustment device to 96 mm (arrow -A-). Left-hand notch of vernier scale is reference point.
-
Turn crankshaft until flywheel TDC marking aligns with point of setting device (arrow -B-).
All vehicles
-
Lock camshaft using setting bar.
-
Centralize setting bar as follows:
Turn camshaft so that one end of setting bar contacts the cylinder head. Using feeler gauge establish the gap at the other end of the setting bar.
Place a feeler gauge corresponding to half the gap between setting bar and cylinder head. Turn camshaft until the setting bar contacts the feeler
gauge. Place a 2nd feeler gauge, of same thickness, at the other end between setting bar and cylinder head
-
Lock injection pump sprocket with pin.
-
Loosen injection pump sprocket mounting bolts -1-.
Note: Do NOT loosen hub nut -2-! Otherwise the Diesel injection pump basic setting will be altered and cannot be reset with normal
workshop equipment.
-
Loosen tensioner.