Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Install 1 0-222A support with 1 0-222A/1 legs as shown.
-
Remove engine mount -1- as follows:
-
Unscrew bolts (arrows)
-
Remove vibration damper/belt pulley.
-
Remove toothed belt guard center and lower sections.
-
Mark engine direction of rotation on the toothed belt.
-
Remove toothed belt.
Toothed belts, installing
-
Make sure that TDC mark on flywheel and reference mark are aligned.
-
Loosen camshaft sprocket mounting bolt 1/2 turn.
-
Place a drift through hole in rear of toothed belt guard and release the camshaft sprocket from camshaft taper with a light and careful hammer
blow.
-
Install toothed belts (note engine direction of rotation) on crankshaft toothed belt sprocket, intermediate wheel, injection pump sprocket and
tensioning roller.
-
Install camshaft sprocket together with toothed belt and position using mounting bolt.
^
Camshaft sprocket should still turn