Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Release socket drive -1- and pull off grip -2-.
-
Turn torque wrench grip -2- 180° and reinsert socket drive.
-
Set wrench direction of turn on socket drive to clockwise.
-
Remove protective cap from pulley.
-
Place 6 mm hex bit socket into generator shaft.
-
Counter hold multi-point socket 3400 with 17 mm box wrench.
-
Insert torque wrench into hex bit socket, loosen freewheel pulley by turning generator shaft clockwise.
-
Remove freewheel pulley after loosening.
Installing
-
Insert multi-point socket 3400 in freewheel pulley.
-
Screw freewheel pulley by hand onto generator drive shaft until stop is reached.
The torque wrench must be rearranged before installing the freewheel pulley as follows: