Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Remove hex bolts -1- and -2-,
-
Remove pump.
Installing
-
Fill power steering pump with hydraulic oil via suction union.
-
Turn hub by hand until oil emits from pressure side.
-
Install power steering pump into bracket and tighten bolts to 25 Nm (18 ft. lbs.).
-
Install suction hose and hose clamp.
-
Marking (arrow -A-) must align with casting seam (arrow).
-
Hose clamp must close off marking (arrow -B-).
-
Install new seals onto banjo bolt.
-
Tighten banjo bolt to 38 Nm (22 ft. lbs.).
The remainder of the installation is the reverse of removal.