volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Power Steering Gear, Removing and Installing|Page 6467 > < Power Steering Gear, Removing and Installing|Page 6465
Page 1
background image

Steering Gear: Service and Repair
Power Steering Gear, Overview

The power steering gear is not serviceable. If problems in the unit are suspected, determine the cause using pressure and leakage tests: if
malfunctioning replace complete unit.

WARNING:  
-

Replace self-locking nuts and bolts.

-

Do not re-use any fasteners that are worn or deformed in normal use.

-

Some fasteners are designed to be used only once, and are unreliable and may fail if used a second time. This includes, but is not limited
to, nuts, bolts, washers, circlips and cotter pins. Always follow the recommendations in this data-replace these fasteners with new parts
where indicated, and any other time it is deemed necessary by inspection.

-

Do not attempt to weld or straighten the steering components or load bearing components of the suspension. 

Notes:  
-

To grease the rack only use steering gear grease Part No. A OF 063 000 04.

-

Type of oil: Hydraulic oil Part No. G 002 000.

-

Oil system capacity 0.7 - 0.9 L (11.8 - 15.2 oz.).

CAUTION:  Part numbers are listed here for reference only. Always check with your Parts department for the latest information.

1. Tie rod end

-

Checking, Refer to Tie Rod.

2. Hex nut

-

50 Nm (37 ft. lbs.) 

3. Clamp

-

Always replace

-

Tightening, refer to Tie Rod.

4. Boot

-

Must not be twisted after adjusting toe

-

Remove steering gear to replace

5. Clamp

-

Always replace

-

Tightening, refer to Tie Rod.

6. Tie rod

-

75 Nm (55 ft. lbs.) 

-

Removing and installing.

-

Replacement parts are supplied preset

Power Steering Gear, Removing and Installing|Page 6467 > < Power Steering Gear, Removing and Installing|Page 6465