Beetle L4-1.9L DSL Turbo (ALH) (1998)
1
Bolt, 4 Nm (35 inch lbs.)
2
Manual selector valve control Adjusting
3
Selector shaft with selector segment
^
Removing and installing refer to Fig. 2
4
Spring pin
^
Driving out and in refer to Fig. 1
5
Engaging lever Insert together with selector shaft and detent segment
6
Detent segment
^
Insert together with selector shaft and engaging lever
7
Lock washer
8
Bolt, 10 Nm (7 ft. lbs.)
9
Spring for selector segment
10
Bolt, 10 Nm (7 ft. lbs.)
11
O-ring
^
Always replace
^
Only install on shafts with groove for circlip
12
Washer
13
Shaft for detent lever
^
Secured by circlip and bearing cap of drive pinion
14
Return spring
15
Detent lever
^
Inserting with return spring Fig. 4
16
Parking lock gear
^
Rounded side faces teeth of drive pinion
17
Bolt, 14 Nm (10 ft. lbs.)
18
Supporting plate
^
Installing refer to Fig. 3
19
Guide plate
^
Insert before supporting plate Fig. 3
20
Transmission housing
^
It is not necessary to remove drive gear to disassemble parking lock
21
O-ring
^
Always replace
22
Multi-function Transmission Range Switch -F125-
^
Insert with 1 pin each resting on slope of detent segment
^
Tested in vehicle by On Board Diagnostic (OBD).
23
Retainer
^
For multi-function switch
24
Bolt, 10 Nm (7 ft. lbs.)
25
Mounting bushing
^
Removing refer to Fig. 5
^
Installing refer to Fig. 6
26
O-ring
^
Always replace
27
Vehicle Speed Sensor (VSS) -G68- Tested by On Board Diagnostic (OBD)
28
Bolt, 10 Nm (7 ft. lbs.)
29
O-ring
^
Always replace
30
Transmission Speed Sensor (VSS) -G38-
^
Tested by On Board Diagnostics.
31
Bolt, 10 Nm (7 ft. lbs.)
32
Retainer
^
For wire to Vehicle Speed Sensor (VSS) -G68-
^
Secure with bolt -item 31 -
33
Retaining clip
^
For wire to VSS
34
Lever
^
For selector shaft
35
Bolt, 10 Nm (7 ft. lbs.)
36
O-ring
^
Pry out with screwdriver
^
Drive in flush with VW 423
37
Breather cap
38
Breather
39
Breather pipe