Beetle L4-1.9L DSL Turbo (ALH) (1998)
/Page-1047002.png)
^
When you adjust the planet carrier, install components in transmission housing without shim (item 17).
1
Input gear
^
Do not remove to adjust planet carrier
^
Input gear or axial needle bearing for planet carrier, removing and installing.
2
Axial needle bearing washer
^
Insert smooth side in input gear
3
Axial needle bearing
4
Axial needle bearing washer
5
O-ring
^
Insert into planet carrier.
6
Planet carrier
7
Transmission housing
^
With input gear and axial needle bearing
^
Axial needle bearing remains in input gear
^
If axial needle bearing is damaged refer to Input gear, removing and installing.
8
Washer
9
Axial needle bearing
10
Large sun gear
11
Washer
^
Insert into large sun gear.
12
Axial needle bearing
13
Large drive shaft
14
Axial needle bearing
15
Needle bearing
16
Small drive shaft
17
Shim
^
Do not install in planet carrier when adjusting
18
Washer
19
Small drive shaft bolt, 30 Nm (22 ft. lbs.).
Shim -A-, determining
^
Install all components (items 2 to 16) into transmission housing to adjust planet carrier.
^
Insert screwdriver through hole of large sun gear to loosen and tighten bolt for small input shaft.
