Beetle L4-1.9L DSL Turbo (ALH) (1998)
Shift Interlock Cable: Adjustments
CAUTION!
Follow the adjustment procedure exactly as outlined.
Adjustment conditions:
^
Locking cable must be routed correctly
^
Center console is removed.
^
Selector lever is in "P"
^
Ignition key is removed.
Adjustment sequence:
^
Slide sliding sleeve -1- forward.
^
Release clip -2- by pushing up.
^
Carefully pry up at four corners of bracket -7- and remove. Be careful not to damage contact spring for shift lever position indicator
^
Slide 0.8 mm feeler gauge between locking lever and selector lever roller.
^
Pull outer sleeve of locking cable slightly forward in direction of travel -arrow 1- and push red clip down until it engages -arrow 2-.
^
Push sliding sleeve over clip.
^
Ignition key removal lock, checking. See: Testing and Inspection