Beetle L4-1.9L DSL Turbo (ALH) (1998)
Shift Interlock Cable: Service and Repair
Removing:
CAUTION!
^
Before working on the electrical system, obtain radio security code and disconnect battery Ground (GND) strap.
^
When reconnecting battery, always check operation of vehicle equipment.
Installation position of locking cable
1
Footwell vents
2
Support for instrument panel
3
Heater unit
^
Remove steering wheel, handle for steering height and reach adjustment and cover for ignition/starter lock.
^
Turn ignition ON.
^
Move selector lever to " P".
^
Remove clip -2- for locking cable -3-.
^
Pull locking cable out of steering lock -1-.
^
Push down sleeve on selector lever handle.
^
While depressing knob, remove selector lever handle by pulling upward.
^
Remove center console and arm rest if installed.
^
Remove switch bracket.
^
Disconnect locking cable from locking lever at selector mechanism.