Beetle L4-1.9L DSL Turbo (ALH) (1998)
/Page-1095002.png)
^
Remove to drain ATF refer to Fig. 1
^
Screw in to stop
^
ATF level, checking and topping up.
3
Oil pan
4
Bolt, 12 Nm (9 ft. lbs.)
5
Magnet
^
Insert in recess of oil pan
6
Spacer bushing
^
Press into gasket
7
Gasket
^
Always replace
^
Press spacer bushings into gasket
8
ATF screen
^
Installing refer to Fig. 10
9
Bolt, 5 Nm (44 inch lbs.)
10 Gasket
^
Always replace
^
Insert in valve body
11 Valve body
^
Removing refer to Fig. 4
^
Installing Fig. 9
^
Marking Fig. 6
^
Installing seal -item 10-
12 Bolt, 10 Nm (7 ft. lbs.)
13 O-ring
^
For wiring guide
^
Always replace
14 Conductor strip
^
With wiring guide and connector
^
Can be removed and installed with transmission installed
15 Retaining bracket
^
For conductor strip connector, installing refer to Fig. 11
16 Bolt, 20 Nm (15 ft. lbs.)
17 Plug for solenoid valves
^
Remove solenoid valves with 3373 =>Fig. 3
18 Sealing plug
^
Remove before removing and installing free wheel
^
Insert plug so that lug is located in groove on housing refer to Fig. 5
^
Place O-rings onto sealing plug
19 O-ring
^
Always replace
20 O-ring
^
Always replace
21 Operating rod for manual selector valve
^
Unhooking refer to Fig. 4
^
Install with stepped side facing manual selector valve refer to Fig. 7
^
Adjusting refer to Fig. 8
Fig. 1 ATF, draining
^
Place container under transmission.
^
Remove plug -2-.
^
Remove overflow pipe -1- and allow ATE to drain.
^
Screw overflow pipe in onto stop.
