Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Install triple-rotor star onto shaft as per markings and drive on up to stop.
-
Install circlip, make sure that it is seated correctly.
-
Install rollers onto triple-rotor star per markings.
-
Slide joint over rollers and hold.
-
Remove axle shaft from vise and re-clamp triple rotor joint housing in vise.
-
Install rectangular section seal (arrow) from repair kit into groove.
The rectangular section seal, seals the triple-rotor joint directly to the joint flange and it is therefore unnecessary to reinstall the cover.
-
Press 90 grams (3.2 oz.) of joint grease, from repair kit, into triple-rotor joint.
-
Press 90 grams (3.2 oz.) of joint grease, from repair kit, into reverse side of triple-rotor joint.
-
Install triple-rotor joint boot.
-
Install clamp.
-
Tighten small clamp using pliers VAG1275.