Beetle L4-1.9L DSL Turbo (ALH) (1998)
-
Check dimension -a- at three points and calculate average.
Specification: 19.5 to 21.1 mm
Note: Because of the hole in the drive plate it is measured on the milled surface of the engine block
If specification not obtained
-
Remove drive plate and install shim -2-.
-
Tighten bolts -3-.
^
30 Nm (22 ft. lbs.)
-
Tighten bolts -3- to 60 Nm (44 ft. lbs.) and turn an additional 90° (1/4 turn) further.
Note: The ]/4 turn additional can be achieved in more than one step.