Beetle L4-1.9L DSL Turbo (ALH) (1998)
A Separating device, 22 - 115 mm, e.g. Kukko 17/2
B Bolt,17 mm, M10 x 20
Note:
Support separating device so that the 1st and 2nd gear operating sleeve is not pulled off at the same time.
Fig. 6 Pulling off operating sleeve with synchronizer hub via bearing support
A Two-arm puller, e.g. Kukko 20/10 with 250 mm reach hooks
B Hex head bolt, 17 mm, M10 x 20
Note:
Remove circlip before pulling off individual components.
Fig. 7 Pulling off large tapered roller bearing inner race
A Vise clamps
-
Before mounting puller insert an M10 x 20 hex head bolt in output shaft bore.
Fig. 8 Pressing on large tapered roller bearing inner race