Beetle L4-2.0L (AEG) (2000)
-
Check resistance for sensor heater at connector to oxygen sensor terminal 1 + 2: Specified value: 1,0...5,0 Ohms(at room temperature)
If specified value is not obtained:
-
Replace Heated Oxygen Sensor (HO2S) 1 Bank 1 -G39- before catalytic converter.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code. See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If specified value is obtained:
-
Check Ground (GND) activation of oxygen sensor heater.
-
Connect test box to control module wiring harness, connect test box for wiring test. See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For Wiring
Test
-
Check wires between test box and 4-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram. Terminal 2 +
socket 27: Wire resistance: max. 1.5 Ohms
-
Also check wires for short circuit to B+ and Ground (GND). Specified value: Infinite Ohms
-
Check wire between 4-pin connector terminal 1 and Fuel Pump (FP) Relay -J17- for open circuit according to wiring diagram. Wire resistance:
max. 1.5 Ohms
If no malfunctions are found in wires:
-
Replace Motronic Engine Control Module (ECM) -J220-.
Test sequence (Vehicles with engine code AVH, AZG, BDC)
-
Unscrew protective cover (arrows) and disconnect 6-pin harness connector (black) -1- to Heated Oxygen Sensor (HO2S) -G39- before catalytic
converter.