Beetle L4-2.0L (AEG) (2000)
-
Install wheel bearing/hub unit as far as possible onto stub axle.
-
Attach 3420 assembly tool and pull wheel bearing/hub unit fully on up to stop.
-
Remove 3420 assembly tool.
Fig. 7 Securing wheel bearing and hub unit
-
Install new 12-point nut -A- and tighten to 175 Nm (129 ft. lbs.).
-
Install brake disc.
Fig. 8 Driving in dust cap
Notes:
-
Always replace the dust caps.
-
Damaged (dented) dust caps allow moisture contamination, therefore always install using the seal installer shown.
Installation is the reverse of removal.
Fastener/location - Tightening torque
Brake caliper to rear axle: .................................................................................................................................................................... 65 Nm (48 ft. lbs.)
Brake disc to wheel bearing/hub unit: ................................................................................................................................................ 4 Nm (35 inch lbs.)