Eos (1F7) L4-2.0L Turbo (BPY) (2007)
Oil Filter: Removal and Replacement
Oil Filter Bracket
Removing
-
Remove the intake manifold. Refer to => [ Intake Manifold ] See: Intake Manifold/Service and Repair/Intake Manifold.
-
Disconnect the coolant pipes. Refer to => [ Coolant Pipes ] See: Cooling System/Coolant Line/Hose/Service and Repair.
-
Remove the oil cooler bolts - A and B - and cooler.
-
Disconnect the connector - A - from the oil pressure switch and remove the ground wire bolt - B -.
-
Remove the oil filter bracket bolts - arrows - and remove the oil filter bracket.
Installing
-
Replace the gaskets - items 7 and 14 - in => [ Oil Filter Bracket Overview ] See: Service and Repair/Removal and Replacement/Lubrication
System Overview.
-
Install the oil baffle - item 13 -=> [ Oil Baffle ] See: Service and Repair/Removal and Replacement/Lubrication System Overview.
-
Install the oil filter bracket and tighten the bolts uniformly to 15 Nm + an additional 90° (1/4) turn.
-
Install oil cooler with bracket for coolant pipes.
The rest of the installation is basically a reverse of the removal sequence.