Eos (1F7) L4-2.0L Turbo (BPY) (2007)
/l4-2.0l_turbo_(bpy)/Page-4033001.png)
Headlamp Bulb: Procedures
Replacing Halogen Headlamp Bulbs, Valeo
Application and safety notes:
CAUTION!
If assembly work is performed on the headlamps, note the following:
‹› Switch off ignition, switch off all electrical consumers and remove ignition key.
Additional Information:
Illustration depicts the left headlamp as installed.
The right headlamp bulb is replaced is the same way.
The low beam lamp and the turn signal lamp are located behind the housing cover - A -.
The high beam lamp and the parking lamp are located behind the housing cover - B -.
‹› Headlamps are equipped with One Touch System, meaning the lamps can be loosened and removed using a handle.
‹› For reasons of clarity, the headlamps are depicted in the removed state in the following work descriptions.
DTC Recognition and Display:
‹› Lamps can be checked via output Diagnostic Test Mode (DTM) of Vehicle Electrical System Control Module (J519).
Use the Vehicle Diagnosis, Testing and Information System (VAS 5051A) for fault finding.
Replacing bulbs for low beam headlamps manufactured by Valeo, refer to => [ Low Beam Bulbs, Valeo ] See: Service and Repair/Removal and
Replacement/Halogen Headlamps.
Replacing bulbs for front turn signals manufactured by Valeo, refer to => [ Front Turn Signal Bulbs, Valeo ] See: Service and Repair/Removal and
Replacement/Halogen Headlamps.
Replacing bulbs for high beam headlamps manufactured by Valeo, refer to => [ High Beam Bulbs, Valeo ] See: Service and Repair/Removal and
Replacement/Halogen Headlamps.
Replacing bulbs for parking lamps manufactured by Valeo, refer to => [ Parking Lamp Bulbs, Valeo ] See: Service and Repair/Removal and
Replacement/Halogen Headlamps.
