Eos (1F7) L4-2.0L Turbo (BPY) (2007)
/l4-2.0l_turbo_(bpy)/Page-2043004.png)
-
Align new cover with bolts - arrows - to bolt holes.
It must be aligned exactly because it cannot be aligned after driving on.
-
Drive cover on with a plastic hammer.
-
Wipe away any sealant leaking out.
Tightening hose clamp on outer joint
-
Attach CV joint boot clamp tool V.A.G 1682 as shown in illustration. Be sure that edges of clamping pliers are seated in corners - arrows B - of
hose clamp.
-
Tension clamp by turning spindle with a torque wrench (do not tilt clamp tool).
Note:
^
A stainless steel clamp must be used due to hardness of CV boot material (compared to rubber). This clamp can only be tensioned using CV joint
boot clamp tool V.A. G 1682.
^
Torque specification: 25 Nm.
^
Use torque wrench - C - with adjustment range 5 to 50 Nm (e.g. torque wrench V.A. G 1331).
^
Be sure thread of spindle - A - of clamp tool moves freely. Grease with MOS 2 grease if necessary.
^
If it does not move freely, e.g. due to dirt in thread, required clamp tension will not be achieved at specified torque.
Tensioning clamp on small diameter
Outer constant velocity (CV) joint, checking
Inner constant velocity (CV) joint, checking
