Eos (1F7) L4-2.0L Turbo (BPY) (2007)
-
Pry out the seal using the (T20143/1).
-
Lightly lubricate the outer circumference of the new seal.
-
Fill the area between the sealing lip and dust lip - arrow - halfway with sealing grease (G 052 128 A1).
-
Drive in the new seal until seated using the (VW 423).
The rest of the installation follows the reverse order of removal, noting the following:
-
Install the transmission selector lever to the selector shaft of the transmission, refer to => [ Transmission Shift Lever,
Installing ] See: Shifter M/T/Service and Repair/Removal and Replacement/02Q Transmission/Shift Mechanism Overview and tighten the nut - item 17