Eos (1F7) L4-2.0L Turbo (CCTA) (2009)
Alarm Horn: Service and Repair
Alarm Horn
Special tools, testers and auxiliary items required
‹› Drill (VAS 5134)
‹› Drill bit 6 mm
‹› Pop rivet pliers (VAS 5072)
Alarm Horn (H12) is located at right on A-pillar in fender.
‹› To remove the alarm horn, anti-theft alarm system must be deactivated. Refer to => [ Anti-Theft Alarm System, Activating and Deactivating ] See:
Testing and Inspection/Programming and Relearning/Anti-Theft Alarm System, Activating and Deactivating.
Removing:
-
Switch off ignition, switch off all electrical consumers and remove ignition key.
-
Remove right front wheel housing liner.
-
Using (VAS 5134) and a spiral bore 6 mm, drill out both pop rivets - arrows -.
-
Disengage harness connector - 1 - through opening in housing - 2 - using a small screwdriver and remove alarm horn - 3 - out of wheel housing.